How to change engine oil
and filter on TOYOTA
Corolla Verso (AR10) –
replacement guide
SIMILAR VIDEO TUTORIAL
This video shows the replacement procedure of a similar car part on another vehicle
CLUB.AUTODOC.CO.UK 1–10
This replacement procedure can be used for:
TOYOTA Corolla Verso (AR10) 1.6 (ZNR10_), TOYOTA Corolla Verso (AR10) 1.8
(ZNR11_), TOYOTA Corolla Verso (AR10) 1.5, TOYOTA Corolla Verso (AR10) 1.8
The steps may slightly vary depending on the car design.
Important!
This tutorial was created based on the replacement procedure for a similar car part
on: TOYOTA Aygo (AB10) 1
Buy tools
CLUB.AUTODOC.CO.UK 2–10
REPLACEMENT: ENGINE OIL AND FILTER – TOYOTA
COROLLA VERSO (AR10). LIST OF THE TOOLS YOU'LL
NEED:
All-purpose cleaning spray
Oil filter cup socket 76/14-F
Impact socket №15
Ratchet wrench
Torque wrench
Oil drain pan
Funnel
Fender cover
CARRY OUT REPLACEMENT IN THE FOLLOWING ORDER:
1
Open the hood.
2
Use a fender protection cover to prevent damaging paintwork and plastic parts of the car.
3
Unscrew the oil filler plug.
4
Lift the car using a jack or place it over an inspection pit.
CLUB.AUTODOC.CO.UK 3–10
Replace the oil filter every time when changing motor oil.
Please note: all work on the car – TOYOTA Corolla Verso (AR10) – should be
done with the engine switched off.
Wear gloves to prevent contact with hot liquid.
The vehicle must be on even keel, and if it is at an angle, the drain plug must be
at the lowest point.
All work should be done with the engine stopped.
AUTODOC recommends:
Replacement: engine oil and filter – TOYOTA Corolla Verso (AR10). Tip from
AUTODOC experts:
5
Put a waste oil container with at least 4 l capacity under the drainage hole.
6
Unscrew the drain plug. Use a drive socket #15. Use a ratchet wrench.
7
Drain the used oil.
CLUB.AUTODOC.CO.UK 4–10
Caution! The oil may be hot.
Wait until the oil has completely drained from the drainage hole.
Replacement: engine oil and filter – TOYOTA Corolla Verso (AR10). Tip from
AUTODOC:
8 Move the container under the oil filter.
9
Unscrew the oil filter. Use the 76/14-F socket.
10
Prepare a container for the old oil filter. Put the old oil filter in the container.
11
Clean the oil filter seat.
CLUB.AUTODOC.CO.UK 5–10
Move up the container. The oil starts to drain out of the drainage hole
immediately after you have removed the oil filter.
Replacement: engine oil and filter – TOYOTA Corolla Verso (AR10). Tip:
12
Lubricate the rubber seal of the new filter with a little amount of fresh oil.
13
Screw the new filter into its place. Use the 76/14-F socket. Use a torque wrench. Tighten it to 23 nm torque.
14
Clean the area of the oil pan drainage hole.
15
Screw in the new drainage plug and tighten it. Use a drive socket #15. Use a torque wrench. Tighten it to 27 nm
torque.
CLUB.AUTODOC.CO.UK 6–10
16
Clean the area of the oil pan drainage hole. Use all-purpose cleaning spray.
17
Lower the car.
18
Remove the oil filler cap. Insert the funnel.
19
Pour oil into the engine through the filler. Required amount of oil: 3.6 L.
CLUB.AUTODOC.CO.UK 7–10
Use the oil recommended by the manufacturer.
Replacement: engine oil and filter – TOYOTA Corolla Verso (AR10). Professionals recommend:
20
Check the oil level using the dipstick. Top up oil if necessary.
21
Tighten the oil filler cap.
22
Run the engine for a few minutes. After the oil pressure warning light goes out, stop the engine.
23
Check the oil level 5 minutes after the stop of the engine operation using a dipstick and add oil if necessary.
CLUB.AUTODOC.CO.UK 8–10
The oil level should be between the Min and Max marks.
Please note!
24
Remove the fender protection cover.
25
Close the hood.
VIEW MORE TUTORIALS
CLUB.AUTODOC.CO.UK 9–10
The oil level should be between the Min and Max marks.
Make sure that the oil filler cap is properly tightened.
Check the threaded plug of the drainage hole and the oil filter seal for tightness.
If necessary, carefully tighten them up.
Note that oil pressure warning light, which indicates insufficient pressure in the
lubrication system, may be on for a longer time than usual. After a few seconds,
the oil will fill all the channels, and the light will go out.
To protect the environment from pollution, be sure to dispose of the used filters
at special collection points.
WELL DONE!
Replacement: engine oil and filter – TOYOTA Corolla Verso (AR10). AUTODOC
recommends:
Replacement: engine oil and filter – TOYOTA Corolla Verso (AR10). AUTODOC
experts recommend:
AUTODOC — TOP QUALITY AND AFFORDABLE CAR
PARTS ONLINE
A GREAT SELECTION OF SPARE PARTS FOR YOUR CAR
OIL FILTER: A WIDE SELECTION
The document contains only general recommendations that may be useful for you when you perform repair or replacement work. AUTODOC shall not be liable
for any loss, injury, damage of property occurring in the repair or replacement process due to incorrect use or misinterpretation of the provided information.
AUTODOC shall not be liable for any possible mistakes and uncertainties in this guide. The information provided is for information purposes only and cannot
replace advice from specialists.
AUTODOC shall not be liable for incorrect or hazardous usage of equipment, tools and car parts. AUTODOC strongly recommends to be careful and observe
the safety rules when performing repair or replacement works. Remember: usage of low quality auto parts does not guarantee you the appropriate level of
road safety.
© Copyright 2022 – All the contents of this website, in particular texts, photographs and graphics, are protected by copyright. All rights, including
reproduction, publication, editing and translation rights, are reserved by AUTODOC GmbH.
CLUB.AUTODOC.CO.UK 10–10
DISCLAIMER:
AUTODOC MOBILE APP: GREAT DEALS AND CONVENIENT
SHOPPING